Tag for m/c trailer

[SteveHebert]

I do like the black one as well. Probably the one to get. Here is another question for you Uni goers. The lid does not close evenly. There is a slight gap on one side. Are the hinges adjustable so I can square it off? I have not tried anything yet.

Thanks for the info.

[txtinman]

I have the same problem here in Texas. My tag on the Unigo looks crazy it's so big.

Keep an eye on the front plate where the hitch bar is bolted. The welds on mtn broke 2 years ago as I was pulling in to the Chicken Rally. I had to find a welder to temp repair it. when I got it back to Texas I replaced the OEM plate with one thicker and better welds. The original welds were not very good. My Unigo was made in New Zealand. If yours was made here in the USA maybe the welds are better. The problem is you can't see the welds because they are covered. Just keep a look out for any loosness or a change in the angle of the hitch bar.

That's the only problem I've had with mine. I've pulled it all over the place and I love it.

[SteveHebert]

Thanks for th info Mike.

[dkl]

Don

Steve you can guest loosen the hinges little and square the top to then tighten them back not to much remember it's fiberglass. Do you have the bra? I f you go on a long trip and get crud behind the bra it will eat the finish. I am going to take my trailer to Linex and get a bra coated on.

[SteveHebert]

Thanks Don. I tried that already but when i tightened them, it went back to the same setting. I will be more patient and try again when i am home again in June.